CNC motor won't work
2 posters
Page 1 of 1
CNC motor won't work
by Seniorgeek Tue Mar 08, 2016 8:01 pm
Today I tried to do some CNC cutting and the software loaded fine but I could not get the CNC mill motor to start. I took a reading at the power supply and should have 48VDC at the motor connectors. I got 0 voltage. I expect the power supply died.
Any one else tried the motor to see if it will work?
Any one else tried the motor to see if it will work?
Seniorgeek- Senior Member
- Posts : 47
Join date : 2016-01-04
Location : Eastern Shore USA
Re: CNC motor won't work
by Prisonbreak Fri Mar 11, 2016 3:37 am
This is a CNC power supply.
1 is a switch
2 is a lamp, when the switch is on
3 is to adjust the voltage 0~48V
You can try again.
1 is a switch
2 is a lamp, when the switch is on
3 is to adjust the voltage 0~48V
You can try again.
- Attachments
- CNC POWER.jpg You don't have permission to download attachments.(49 Kb) Downloaded 11 times
Prisonbreak- Junior Member
- Posts : 5
Join date : 2016-02-29
Re: CNC motor won't work
by Seniorgeek Fri Mar 11, 2016 11:20 am
[quote="Prisonbreak"]This is a CNC power supply.
1 is a switch
2 is a lamp, when the switch is on
3 is to adjust the voltage 0~48V
You can try again.[/quote]
I already fixed the problem. The power line to the switch was broken. See post in hardware.
1 is a switch
2 is a lamp, when the switch is on
3 is to adjust the voltage 0~48V
You can try again.[/quote]
I already fixed the problem. The power line to the switch was broken. See post in hardware.
Seniorgeek- Senior Member
- Posts : 47
Join date : 2016-01-04
Location : Eastern Shore USA
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
» Formmaker for sale for parts
» Crap machine
» Upgrade Formaker
» Incorrect dimensions after printing
» Heat bed temperature incorrect
» Timing pulleys for Formaker
» Heat Bed Resistance
» Replacement power supply