Unboxing images

The following are images right out of the box with description of each.
This is how the box looked as I opened it.
https://i.servimg.com/u/f84/19/39/34/30/openbo10.jpg

This is out of the box front view.
https://i.servimg.com/u/f84/19/39/34/30/openon10.jpg

This is out of the box back view.
https://i.servimg.com/u/f84/19/39/34/30/back-b10.jpg

This is the top view.
https://i.servimg.com/u/f84/19/39/34/30/opento10.jpg

This is the accessories package.
https://i.servimg.com/u/f84/19/39/34/30/access10.jpg

Next I have to figure out how to put images directly in the post instead of links.

This is the mounting hardware including the laser etcher.
https://i.servimg.com/u/f84/19/39/34/30/includ10.jpg

This is looking in the top while the packing is still inside. Note the inventory list.
https://i.servimg.com/u/f84/19/39/34/30/top-op10.jpg

This view is looking at the Formaker on its side so you can see the mount plate.
https://i.servimg.com/u/f84/19/39/34/30/underp10.jpg

This is the included CNC tool with power supply.
https://i.servimg.com/u/f84/19/39/34/30/cnctoo10.jpg

This is a picture of the screws I found in the bottom of the box. Be sure to unpack very carefully ans stuff falls to the bottom.
https://i.servimg.com/u/f84/19/39/34/30/screws10.jpg

This is the picture of the tool holder inside the Formaker.
https://i.servimg.com/u/f84/19/39/34/30/toolmo11.jpg

Now I have to figure out how to include the images in the post instead of the links.



[url=//www.pinterest.com/pin/create/extension/][/url]

[url=//www.pinterest.com/pin/create/extension/][/url]

[url=//www.pinterest.com/pin/create/extension/][/url]

[url=//www.pinterest.com/pin/create/extension/][/url]