MakerBot Software latest version
2 posters
Page 1 of 1
MakerBot Software latest version
Hi all,
I installed the latest makerbot software. It differs a bit from the version which is described in the formaker manual but I found my way around.
What I didn't find out is how to restrict the software to only use a single extruder - as I only have one roll of filament and am only printing a single material.
I downloaded something from thingiverse, set the device type to "Replicator (Dual)" and exported the 3d model to file (x3g).
Even when I selected "replicator (single)" as device, the printer wanted to use both extruders.
Any advise how this can be done?
Thanks,
Gregster
I installed the latest makerbot software. It differs a bit from the version which is described in the formaker manual but I found my way around.
What I didn't find out is how to restrict the software to only use a single extruder - as I only have one roll of filament and am only printing a single material.
I downloaded something from thingiverse, set the device type to "Replicator (Dual)" and exported the 3d model to file (x3g).
Even when I selected "replicator (single)" as device, the printer wanted to use both extruders.
Any advise how this can be done?
Thanks,
Gregster
gregster- Member
- Posts : 22
Join date : 2016-02-12
Re: MakerBot Software latest version
Hello
You must go to the control screen and setting , and in place the left extruder to OFF
You must go to the control screen and setting , and in place the left extruder to OFF
delirium07- Member
- Posts : 10
Join date : 2016-01-09
Similar topics
» IOS software
» Included software first impression
» Open Source software recommendation
» CTC-TG MacOS version
» ReplicatorG Software: Translation/Config Needed
» Included software first impression
» Open Source software recommendation
» CTC-TG MacOS version
» ReplicatorG Software: Translation/Config Needed
Page 1 of 1
Permissions in this forum:
You cannot reply to topics in this forum
Fri Dec 01, 2017 8:10 am by sid
» Formmaker for sale for parts
Mon Feb 20, 2017 3:40 pm by Seniorgeek
» Crap machine
Mon Feb 20, 2017 3:34 pm by Seniorgeek
» Upgrade Formaker
Wed Feb 01, 2017 8:51 am by Mikael
» Incorrect dimensions after printing
Wed Feb 01, 2017 8:36 am by szalap
» Heat bed temperature incorrect
Tue Nov 22, 2016 7:01 pm by CKAFamily
» Timing pulleys for Formaker
Thu Nov 17, 2016 9:25 am by szalap
» Heat Bed Resistance
Thu Nov 03, 2016 5:33 pm by CKAFamily
» Replacement power supply
Wed Oct 05, 2016 4:28 pm by Seniorgeek